SpeedyBee Bluetooth-UART Adapter for RC FPV Flight Control Parameter Settings

SpeedyBee Bluetooth-UART Adapter for RC FPV Flight Control Parameter Settings

Buy Today

£14.95

Parameter:

 1.Output Power: 0dBm

 2.Receiver Sensitivity: -94 dBm

 3.External Interfaces: BROADCAST SWITCH, TX, RX, 3~5V DC Input, GND

 4.Transmission rate: Bidirectional 1K/S

 5.Bluetooth Protocol: Bluetooth Specification V4.0 BLE

 6.Transmission distance: 30m

 7.Frequency range: 2400 MHZ – 2483.5MHZ(2.4G ISM Band)

 8.Baud rate: 2400,4800,9600,14400,19200(default),28800,38400,57600,76800,115200,230400

 9.Operating Voltage: 3.3V – 5.0V DC

10.Working current: 8.3mA~10mA

11.Weight: 1.4g

12.Dimensions: 27*15*4.5mm

Flight Controller Requirements:

Betaflight firmware version ≥ 3.1.0

System Requirements : Android 4.3 + / iOS 10.0+

Instructions for use:

1.Connect the Bluetooth PCB with the UART interface of the Flight Controller, or use the flight 

controller integrated Bluetooth.

2.Open the Betaflight Configurator, on the Ports tab, open the Configuration/MSP port of the Bluetooth 

PCB, for the Bluettooth module of BLE4.0, 19200 is the recommended baud rate value.

3.Open the APP, connect the Flight Controller via Bluetooth, and you can adjust the parameters now.

Notes:

Currently only betaflight configurator supported.

Package Included:

1 x Bluetooth PCB

1 x 5PIN Cable

1 x 3M Double-sided Tapes

1 x Heat shrink tube

1 x Manual

Speedybee bluetooth module: Parameter setting of flight controller through speedybee app
Speedybee app: Search “SpeedyBee” on the App Store or Google Play to find
It support the Betaflight Configurator
iOS and Android APP allow you to connect the Flight controller PCB via a mobile device for parameters settings.
No Bluetooth signal interference during the flight

0
Like
Save

Comments

Write a comment

*