Matek PDB , Power Distribution Board , 6 ESC Output ( Input 9-18V , PDB 4*25A or 6*15A , BEC 5V&12V , with XT60 , 1.6mm PCB ) for X or H Design FPV Racing RC Drone Quadcopter by LITEBEE

Matek PDB , Power Distribution Board , 6 ESC Output ( Input 9-18V , PDB 4*25A or 6*15A , BEC 5V&12V , with XT60 , 1.6mm PCB ) for X or H Design FPV Racing RC Drone Quadcopter by LITEBEE

Buy Now

£7.99


DOWNLOAD MANUAL:http://www.mateksys.com/downloads/PDB-XT60_Manual_EN.pdf

General:
– Input voltage range (3S-4S LiPo operation): 9 – 18V DC
– Regulated 5V and 12V outputs
– LED power indicators ( 5V andamp; 12V outputs )
– 6 ESC outputs andamp; 1 pair VCC/GND pads

ESC outputs:
-Continuous current: 25A*4 or 15A*6
– Peak current (10 seconds/minute): 30A*4 or 20A*6

BEC 5V output:
– Designed for RC Receivers, Flight controllers, OSD, and Servos.
– DC/DC synchronous buck regulator.
– Voltage: 5.0 +/- 0.1VDC
– Continuous current: 2 Amps (Max.2.5A 10s/minute)
– Output Ripple: 40mV (VIn=16V, VOut=5V2A load)
– Short-circuit tolerant (5 seconds/minute)

BEC 12V output:
– Designed for Video TX or FPV camera with linear regulator.
– The battery should be 4S LiPo (1318V DC)
– Voltage: 12.0 +/- 0.3VDC
– Continuous current: 500mA (Max.0.8A 5s/minute)
– Short-circuit tolerant (2 seconds/minute)

BEC 12V 3S LiPo
– Output voltage= 3S LiPo voltage -1V

Physical:
– Dimensions: 36 x 50 x 4 mm (without XT60)
– Mounting: 30.5 x 30.5mm, Φ3mm
– Weight: 7.5g(without XT60), 11g(with XT60)
——————————————————————————
Package Including
1 * Matek XT60 PDB
1 * XT60The PDB-XT60 has been engineered to providethe highest possible performance and reliability in a 36*50mm 4 layers PCB.
It distributes power from a Lipo pack to 6 ECSc, as well as providing sybchronised regulated DC 5V outputs linear regulated DC 12V for powering Camera,Servos, RC Receiver, Flight Controller, Video Transmitters, LEDs, etc.
2oz copper to protect a large current, 4-layers 1.6mm PCB, high current power and BEC Stratification, avoid ground disturbance BEC power current.Built-in XT60 Socket,you need to welded it on the sub-plate
Total 6 pairs ESC solder tabs, fit for H or X type frame. Compatible with a plate rack Which width less than 48mm. Mounting hole Suit for CC3D naze32 SP Racing F3 FC.
5V/2A synchronous rectifier switch BEC 12V/0.5A linear BEC.LED indicators Short circuit tolerant

0
Like
Save

Comments

Write a comment

*