Kakute F4 Flight Controller ( V2 ) Integrated Betaflight OSD , BEC ( ICM20689 with 6-axis gyro , 120A Continuous Current , Input Voltage 7v-42v ) for PFV Racing RC Drone Quadcopter by LITEBEE

Kakute F4 Flight Controller ( V2 ) Integrated Betaflight OSD , BEC ( ICM20689 with 6-axis gyro , 120A Continuous Current , Input Voltage 7v-42v ) for PFV Racing RC Drone Quadcopter by LITEBEE

Buy Now

£35.99


Features:
Supports Betaflight and Cleanflight.
Betaflight OSD. Change PIDs, adjust common configuration parameters, and change video transmitter channel and power level, all using your transmitter sticks and goggles.
Soft-mounting built in. The IMU (“gyro”) chip on this board is mounted on vibration-isolating foam. This means that there is no need to soft-mount the board itself.
New high-performance / low-noise / high sensitivity IMU. ICM20689 with 6-axis gyro and accelerometer. Can run at up to 32 kHz.
2 oz. copper PCB allows up to 120A maximum continuous current.
Dedicated bootloader button for easy firmware flashing.
Low-profile design fits into even very compact frames.
Input voltage 7v to 42v. Power the board directly from the flight pack, up to 6S (on “B+” pad only).
Automatic voltage monitoring. No need to run a separate vBat wire for voltage monitoring; the Kakute F4 AIO monitors voltage directly from the battery power lead.
Filtered voltage output for clean, noise-free video. On-board regulators output 5v at up to 1.5 amps and 3.3v at up to 200 mA to power peripherals such as receiver, video transmitter, FPV camera, or LED strip.
Supports BLHeli pass-through for easy ESC upgrade and configuration.
——————————————
Specifications:
Dimensions: 35x30x8mm (includes USB in height)
Mounting Holes: Standard 30.5mm square to center of holes
Weight: 7g5 hardware UARTS (UART1, 3, 4, 5, 6), Additional UART (UART 4) added to support serial camera communication such as to RunCam Split. Additional UART (UART 5) added to support ESC telemetry such as from BLHeli_32 and KISS.
MCU: STM32F405RGT6 32-bit processor. IMU: ICM20689 (SPI). Barometer: BMP280. I2C pad available for certain external sensors. Barometer sensor on board allows altitude hold mode.
Supports serial receivers (SBUS, iBus, Spektrum, Crossfire) only. PPM and PWM receivers are not supported.
USB VCP Driver (all UARTs usable simultaneously; USB does not take up a UART); 128 Mbit Dataflash chip for Blackbox logging
Through-hole solder pads instead of flat pads for more secure soldering especially for beginners.

0
Like
Save

Comments

Write a comment

*