GEHOO GH Happymodel Quadcopter Mantis 85 Micro FPV RACING DRONE BNF with Frsky D8/Flysky 8ch/Specktrum DSM2 Receiver (Flysky 8ch AFHDS 2A receiver)

GEHOO GH Happymodel Quadcopter Mantis 85 Micro FPV RACING DRONE BNF with Frsky D8/Flysky 8ch/Specktrum DSM2 Receiver (Flysky 8ch AFHDS 2A receiver)

Buy Today

£88.88


Specifications:
Item Name:Mantis 85 Micro FPV RACING DRONES BNF
Flight controller: Super_S F4 Flight controller built-in Betaflight OSD
Motor: Happymodel SE1102 KV9000 brushless motor
Propeller: 1935 3-blades propeller
Camera: 600TVL HD CMOS 1/4inch 
Firmware of Flight controller :Betaflight 3.2.0
Flight time : 4minutes 
Buzzer Ready

BNF version Receiver Option:
Frsky D8 modee SBUS receiver (RSSI ready)
Flysky 8ch AFHDS 2A receiver 
Specktrum DSM2/DSMX Compatible receiver

Features:
3K full carbon fiber bottom plate set up with  CNC aluminum alloy Stiffeners 
Extremely light and more powerful 
STM32F405RGT6 MCU+ BLHELI_S ESC make your Operating feel more stabile and silky
Adjustable Angle of Camera 
Jaw-dropping flight performance
Betaflight support
Acro mode / Air mode /Angle mode support 
Built-in OSD(Using F4 MCU controls OSD over SPI bus in DMA mode)
OSD Configuration has been include in BETAFLIGHT GUI
Radio Stick to control PID Tunes
BLEHELI_S pass-through ready
Telemetry RSSI Output ready

Package include:
1 x Happymodel Mantis 85 Frame kit
1 x Super_s F4 Flight controller build-in Betaflight OSD
1 x Frsky/DSMX/Flysky AFHDS2A Receiver(optional)
4 x Happymodel SE 1102 KV9000 brushless motor
1 x Super_S BS06D 4 in 1 ESC Dshot600
4 x 1935 3-blades propeller CW
4 x 1935 3-blades propeller CCW
1 x 600TVL HD CMOS 1/4 inch  camera
1 x Buzzer
1 x DSM2/DSMX Bind module(Only DSMX Version included)Mantis 85 Micro FPV RACING DRONES BNF
Flight controller: Super_S F4 Flight Controller Built-in Betaflight OSD
Firmware of Flight Controller :Betaflight 3.2.0
BNF Version Receiver Option:Frsky D8 Modee SBUS Receiver (RSSI ready) /Flysky 8ch AFHDS 2A Receiver/Specktrum DSM2/DSMX Compatible Receiver
3K Full Carbon Fiber Bottom Plate Set Up with CNC Aluminum Alloy Stiffeners

0
Like
Save

Comments

Write a comment

*